Magura HS33 User Manual download pdf (Page 11)

www.magura.com

1. HS 33 models. Turn the red Turbo Pad Adjuster (TPA) fully clockwise. Turn the

2mm reach adjust setscrew B fully counterclockwise (2mm allen screw).

2. HS 11. Turn the 4mm allen bolt fully counterclockwise.

3. HS 66. Turn the 2mm allen bolt fully counterclockwise.

4. Mount the hose installation kit for the rearbrake. Measure the distance between

both cablestops. Due to shrinkage, cut a length of heatshrink tube that is 10mm

longer than the measured distance.

5. Slide the fixed barrel of the carrier cable into the rear cablestop. Slide the heats-

hrink tube over the cable.

6. Slide the adjustable barrel over the cable and pull the cable firmly through the

other cablestop with pliers. Push, with the pliers, the adjustable barrel against the cable-

stop and tighten the 2mm bolt with an allen key. Cut off the remaining cable so that it is

flush with the barrel.

7. Unscrew the 8mm sleeve nut at the slave cylinder and pull out the hose carefully.

Never activate the lever blade with the system open! Hold the tubing carefully

in order to avoid any loss of oil!

9. Shorten and route the hose

Español Italiano Nederlands Français English Deutsch

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 19 20

No comments

Magura HS33 User Manual Page 11